Diamond wire cutting for graphite blocks, elettrodi, carbon composites and graphite felt — the cleanest way to cut a material that destroys most other tooling.

Filtro
Laboratorio applicazioni
Inviataci il vostro materiale — rapporto di taglio di prova gratuito
Indicate materiale, spessore e tolleranza richiesta. Tagliamo un campione con la nostra sega a filo diamantato e vi restituiamo specifica del filo, avanzamento, finitura superficiale e tempo ciclo.

Why graphite is a wire job

Graphite is abrasive, porous and dusty. A blade saw generates a dust cloud, wears quickly and leaves a rough face that needs a second operation. A diamond wire cuts with a narrow kerf, contains the debris in the coolant, and leaves a face that is often usable directly — especially on electrode stock where the cut face becomes a functional surface.

The economics are driven by something other than cutting speed: dust extraction and tool wear. Wire eliminates most of both.

Grades behave differently

GradoWire ØFeedNote
Fine-grain isostatic (ISO-63 and finer)0.250,35 mm0.5–1,5 mm/minCuts clean; edge chipping is the limit
Medium-grain extrusion0.30–0.50 mm1.0–3.0 mm/minVeloce; expect some edge loss
Graphite felt / soft felt0.40–0.80 mm5–20 mm/minCompresses — needs a supported cut
Carbon-carbon composite0.30–0.50 mm0.5–2.0 mm/minAnisotropic; delamination at high feed

The dust problem

Graphite dust is conductive, persistent and gets into everything. Two practical rules: flood the cut so dust leaves as a slurry rather than as airborne fines, and filter the coolant loop to a finer grade than you would for metal. A recirculating system without adequate filtration turns the dust into a lapping compound that wears guides and pumps.

Electrode machining specifically

For EDM electrodes the cut face quality matters because it becomes the burning surface. A wire-cut face on fine-grain graphite typically needs no further finishing, which removes a milling step from the route. That is usually the whole business case.

Domande frequenti

Does diamond wire wear faster on graphite than on metal?

The abrasive does not wear faster — graphite is soft. The wire fails from dust ingress into the guide system and from coolant contamination, which is a maintenance problem rather than a wire problem.

Can I cut graphite dry?

You can, with extraction. In practice wet cutting is cleaner and keeps the dust out of the operator's environment, which is the deciding factor in most workshops.

Why does my graphite edge chip?

Feed is too high for the grain size, or the part is unsupported at the exit. Fine-grain grades chip before they show any other symptom, so they are the useful early indicator.