Machine platforms for diamond wire cutting: single-wire, 멀티와이어, endless-loop and CNC profilers. This page is the entry point to the material-specific configurations below.

필터
애플리케이션 랩
소재를 보내주시면 무료 테스트 절단 보고서를 드립니다
소재, 두께, 목표 공차를 알려주세요. 자체 다이아몬드 와이어쏘로 시편을 절단하고 와이어 사양, 이송 속도, 표면 조도, 사이클 타임을 회신합니다.

Four machine architectures, four different jobs

"다이아몬드 와이어 톱" covers machines that share a cutting principle but almost nothing else. Choosing the wrong architecture is the most expensive mistake in this category, because it cannot be fixed by changing the wire.

Architecture최적용와이어Practical limit
Single-wire loop sawOne-off cuts, thick sections, profilingEndless loop, 0.3–1.0 mmThroughput — one cut at a time
Multi-wire spool sawBatch slicing of brittle blocksOpen-end, 0.10–0.35 mmCannot do contours; jig-bound
CNC wire profiler2D/2.5D shapes, tapers, arcsLoop or spool, 0.2–0.6 mmCut depth per pass; programming time
Special-shaped / 갠트리Large panels, tube sections, 합성물Loop, 0.4–1.2 mmFloor space; workpiece handling

How to read a machine specification sheet

Most sheets lead with maximum workpiece size and headline feed rate. Neither predicts whether the machine will hold tolerance on your part. The four numbers that do:

  • Guide roller runout — a wire saw cannot cut straighter than its guides allow. Sub-10 µm runout is the threshold for optical and wafer work.
  • Tension stability under load — ask for the tension droop at rated feed, not the set-point resolution.
  • Thermal symmetry — where the heat goes when the machine runs for six hours. Asymmetric frames drift, and drift shows up as taper.
  • Wire consumption at rated output — the operating cost that dominates a three-year view.

Matching the machine to the material

The material decides the architecture more than the part size does. Hard and brittle ceramics reward stiffness and small wire; metals and composites reward loop wire with large diameter and high coolant volume; semiconductors reward thermal stability above everything else.

Use the material pages as the starting point: each one carries the wire specification range, the parameter sequence and the inspection points that matter for that material family.

자주 묻는 질문

Is a bigger machine always more capable?

아니요. Larger machines trade stiffness for envelope. A 200 mm part cut on a large gantry saw will usually hold worse tolerance than the same part on a small single-wire machine, because the wire span is longer and the frame deflects more under tension.

What decides whether I need a loop or a spool?

Cut length and part count. Loop wire is reused until the abrasive dulls, so it wins on short cuts and one-offs. Spool wire is used once, so it wins wherever consistent surface finish across thousands of cuts matters more than wire cost.

Can I retrofit a rotary table to a 2-axis saw?

Usually not worth it. Adding an axis to a machine whose frame was not designed for the resulting load path produces a machine that is worse than either a proper 4-axis profiler or a dedicated 2-axis saw.