Send us a sample of the material you need to cut. We cut it on our own diamond wire saw and send back a process report — wire specification, 送り速度, surface finish and cycle time — at no cost and no obligation.
What you get back
- Wire recommendation — diameter, abrasive grit and bond type for your material, with the reason for each choice.
- Process parameters — feed rate, wire speed and tension as actually run on your sample.
- Measured results — cut time, kerf width, and surface roughness (Ra) where the material allows measurement.
- Photographs of the cut face and the entry/exit edges, at magnification.
- A machine recommendation — the platform that would run this part in production, でなぜ.
What to send
One piece is usually enough. Two is better if the material is inhomogeneous.
| Item | Guidance |
|---|---|
| Sample size | Enough for 3–5 cuts. Typically 50 × 50 ミリメートル, or a full section of the profile you actually cut. |
| Quantity | 1–2 pieces. For very expensive material a single small offcut is fine. |
| Material data | Grade, 硬度, density or datasheet if you have one. If not, tell us what it is used for. |
| Target requirement | What the cut has to achieve: 許容差, surface finish, edge quality, or minimum strength retention. |
| Constraints | Anything the process must not do — no coolant residue, no heat, no chipping on a specific face. |
Mark the intended cut line on the sample if orientation matters. For anisotropic materials — composites, single crystals, graphite grades — orientation is often the difference between a clean cut and a failed one.
How it works
- You send the form. 私たちは営業日1日以内に配送先住所と材料に関する質問に返信します.
- サンプルを発送してください. 荷物に商業的価値のないサンプルとしてマークしてください. 税関が懸念される場合、正しい申告文言をお知らせします.
- 切断と測定を行います. 通常到着後3〜5営業日, パラメータ開発が必要な材料はそれ以上かかる場合があります.
- レポートをお渡しします. PDF, パラメータと写真付き, さらにプロセスが生産で可能な場合は機械の推奨も含まれます.
これは何ではないか
これは生産用のロットではありません, また見積もりのための作業でもありません. テストカットを行うのは、結果がワイヤ仕様を推奨する唯一正直な根拠だからです—一般的なパラメータ表は材料間でうまく転用できません. もしあなたの材料がダイヤモンドワイヤに適さないと結論付けた場合, we will say so in the report.
Frequently asked questions
Is it really free?
はい. There is no charge for the cut or the report, and no obligation to buy. You cover the cost of shipping the sample to us.
Do you return the sample?
We can, if you ask. Most customers prefer to keep the cut pieces for their own inspection.
What if my material is hazardous?
Tell us before shipping. Beryllium ceramics, some refractory compounds and dust-generating materials need handling arrangements agreed in advance.
Can you cut under NDA?
はい. Send the form, tell us you need an NDA, and we will send one before any material ships.
How large a sample can you take?
Up to roughly 200 mm in the cut direction on our standard platforms. Larger sections are possible — ask first and we will confirm.
Request your test cut
フォームに記入してください。作業日の1日以内に返信いたします.